Assembling And Adjustments; Unpacking; Assembly; Description Of The Components - Husqvarna 9673168-01 Operator's Manual

ASSEMBLING AND ADJUSTMENTS

Unpacking

Illustration: 1 • 1
IMPORTANT! Make sure to not cut the cables/wires or
scratch the machine when cutting the edges of the case.
References Content of the case
A Engine parts
B Holder comp
C Holder main comp
D Lower tidy cover
E Drag bar
F Tine cover
G Tine cover bracket
H Lever shifting
I Blades
J Wheel
K Connector joint
L Tool bag
M Hardware bag tines only
N Hardware bag

Assembly

Illustration: 1 • 2
WARNING! Inappropriate assembly of this
!
rotary tiller could cause severe injuries.
Ensure that you follow all the instructions
carefully.
• Fitting the tine blades Illustrations only shows assembly of
the tine blades on the right side. Make sure that the sharp
edges face one side on both right and left side tines. There
is one piece of short blade on each side that need bending
to the gearbox when assembling. (Figure 1 - 6)
• Fitting the connecting joint. (Figure 7)
• Fitting the drag bar. (Figure 8)
• Fitting the handle bar. (Figure 9)
• Adjust the hight of the handle and tighten the knobs
securely. (Figure 10)
• Fitting the clutch control. (Figure 11)
- Turn to proper side and fasten the bolt.
• Fitting the lower tidy cover. (Figure 12 - 13)
- Tidy the cables.
- Fit the rubber holder properly.
- Fit the cover and tighten the screws.
• Fitting the tine cover. (Figure 14 - 16)
- Do not tighten the bolt immediately after installed.
- Install all 4 bolts and nuts first, then tighten one by one.
• Fitting the shifting lever. (Figure 17)
Any dismantling operation must only be performed by an
authorized service workshop.
CAUTION! After assembling the machine completly, tighten
the bolts and screws with modertion. Do not overtighten.

Description of the components

Illustration: 1 • 3
1 Engine
2 Tine cover
3 Lower tidy cover
4 Belt cover
5 Blades
6 Drag bar
7 Handle
8 Lever shifting
9 Bumper
10 Clutch control
11 Throttle control
12 ON/OFF switch
13 Upper tidy cover

Type plate

Illustration: 1 • 4
1 Serial number
2 Article number
3 Tilling scope
4 Gear shifting
5 Engine displacement
6 Engine oil Quality (viscosity):
7 Engine oil capacity
8 Gear box oil quality
9 Gear box oil capacity
10 Nominal power
11 Net weight
12 Fuel

Transport wheel

Illustration: 1 • 5
Change the tines to wheels when transporting.
For more information about moving of the machine, see
section "Moving".
– 6
English