Operation - Makita SA7000C Instruction Manual

1. Lock nut
2. Abrasive disc
3. Rubber pad
1
2
1. Lock nut wrench
2. Shaft lock

OPERATION

A B
15
Installing or removing abrasive disc
005021
1
NOTE:
2
• Use sander accessories specified in this manual. These must be
3
purchased separately.
Mount the rubber pad onto the spindle. Fit the disc on the rubber pad and
screw the lock nut onto the spindle. To tighten the lock nut, press the shaft lock
firmly so that the spindle cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
To remove the disc, follow the installation procedure in reverse.
005022
005023
WARNING:
• It should never be necessary to force the tool. The weight of the tool
applies adequate pressure. Forcing and excessive pressure could cause
dangerous disc breakage.
CAUTION:
• Never switch on the tool when it is in contact with the workpiece, it may
cause an injury to operator.
• Never run the tool without the abrasive disc. You may seriously damage
the pad.
• Always wear safety goggles or a face shield during operation.
• After operation, always switch off the tool and wait until the disc has
come to a complete stop before putting the tool down.
ALWAYS hold the tool firmly with one hand on rear handle and the other on the
side handle. Turn the tool on and then apply the abrasive disc to the work-
piece.
In general, keep the abrasive disc at an angle of about 15 degrees to the work-
piece surface.
Apply slight pressure only. Excessive pressure will result in poor performance
and premature wear to abrasive disc.
7