Functional Description - Makita SA7000C Instruction Manual

FUNCTIONAL
DESCRIPTION
1
1. Shaft lock
1. Lock button
2. Switch trigger
1. Speed adjusting dial
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Shaft lock
005016
CAUTION:
• Never actuate the shaft lock when the spindle is moving. The tool may be
damaged.
Press the shaft lock to prevent spindle rotation when installing or removing
accessories.
Switch action
005017
1
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed is increased by
increasing pressure on the switch trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then push in the lock but-
2
ton.
To stop the tool from the locked position, pull the switch trigger fully, then
release it.
Speed adjusting dial
005018
The rotating speed can be changed by turning the speed adjusting dial to a
1
given number setting from 1 to 6 (6 at the time when the switch trigger is fully
pulled).
Higher speed is obtained when the dial is turned in the direction of number 6.
And lower speed is obtained when it is turned in the direction of number 1.
Refer to the table for the relationship between the number settings on the dial
and the approximate rotating speed.
CAUTION:
The speed adjusting dial can be turned only as far as 6 and back to 1. Do not
force it past 6 or 1, or the speed adjusting function may no longer work.
• If the tool is operated continuously at low speeds, the motor will get
overloaded and heated up.
Number
1
2
3
4
5
6
C00115
-1
min (R.P.M.)
1,500
1,700
2,000
2,500
3,300
4,000
5