Operation; Maintenance; Replacing Carbon Brushes - Makita 9032 Instruction Manual

OPERATION

CAUTION:
• Secure the workpiece with clamps, etc. if there
is any possibility of it moving during the work
operations.
• The tool should not already be in contact with
the workpiece surface when you turn the tool
on or off. Otherwise a poor sanding finish, dam-
age to the belt of loss of control of the tool may
result.
• When working with the tool, be very careful to
avoid any contact of the tool and belt with any
part of your body or anyone or anything near
you.
Hold the tool firmly with both hands. Turn the tool on
and wait until it attains full speed. Gently apply the tool
to the workpiece surface and move the tool forward
and back. Press the belt only lightly on the workpiece.
Excessive pressure may damage the belt and shorten
tool life.
Always use "A" range of the belt to sand the workpiece.
"A" range
► 1. Flat shoe

MAINTENANCE

•
•

Replacing carbon brushes

1
► 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
6 ENGLISH
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
1