Operation - Makita 9237C Instruction Manual

Installing or removing the wool
bonnet (optional accessory)
For tools which are equipped with a rubber pad.
3
► 1. Wool bonnet 2. Lock nut 3. Rubber pad
4. Spindle 5. Shaft lock
Mount the rubber pad onto the spindle. Screw the lock
nut onto the spindle.
2
► 1. Lock nut wrench 2. Shaft lock
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the rubber pad, follow the installation proce-
dure in reverse.
Fit the wool bonnet over the rubber pad. Tie a bow knot
and tuck the knot and any loose strings between the
wool bonnet and the rubber pad.
Installing side grip (handle)
(optional accessory)
CAUTION:
•
1
2
Screw the side grip securely on the position of the tool
as shown in the figure.
4
5

OPERATION

1
Polishing operation
CAUTION:
•
Hold the tool firmly. Turn the tool on and then apply the
wool pad/bonnet to the workpiece.
In general, keep the wool pad/bonnet at an angle of
about 15 degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will
result in poor performance and premature wear to wool
pad/bonnet.
7 ENGLISH
Always be sure that the side grip is installed
securely before operation.
Always wear safety glasses or a face shield
during operation.