Maintenance - Makita SA7000C Instruction Manual

MAINTENANCE

1
1. Exhaust vent
2. Inhalation vent
1
1. Commutator
2. Insulating tip
3. Carbon brush
1
1. Brash holder cap
2. Screwdriver
ACCESSORIES
8
005024
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
The tool and its air vents have to be kept clean. Regularly clean the tool's air
vents or whenever the vents start to become obstructed.
2
Replacing carbon brushes
001146
When the resin insulating tip inside the carbon brush is exposed to contact the
commutator, it will automatically shut off the motor. When this occurs, both car-
2
bon brushes should be replaced. Keep the carbon brushes clean and free to
slip in the holders. Both carbon brushes should be replaced at the same time.
Use only identical carbon brushes.
3
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
005025
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
2
CAUTION:
• These accessories or attachments are recommended for use with your
Makita tool specified in this manual. The use of any other accessories or
attachments might present a risk of injury to persons. Only use
accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask
your local Makita service center.
• Rubber pad
• Abrasive discs
• Lock nut
• Lock nut wrench
• Side grip (handle)