Olivetti FAX System M-New Service Manual page 22

Initialization procedure after installing the facsimile system
1. Insert the machine power plug to the wall outlet and turn the main power switch on.
2. Press the status key and enter 10871087 using the numeric keys. The machine enters maintenance mode.
3. Only when the optional dual FAX is installed:
When both the FAX system and the dual FAX are installed: Run maintenance mode U698 using the cursor up
or down key, or numeric keys, press [PORT SELECT], select [ALL] and press the start key.
If the FAX system is already in use and the dual FAX is additionally installed: Run maintenance mode U698,
press [PORT SELECT], select [P2] and press the start key.
4. Run maintenance item U600 using the cursor up/down keys or numeric keys.
5. Press [Execute] and then press the start key.
6. Select [Country Code] and enter a destination code using the numeric keys (refer to the destination code list).
Enter a destination code with three digits.
Code Destination
000 Japan
009 Australia
080 Hong Kong
084 Indonesia
088 Israel
108 Malaysia
126 New Zealand
136 Peru
137 Philippines
152 Middle East
156 Singapore
7. Select [OEM Code], enter the OEM code
(000) and then press the start key.
8. After initialization, the entered destination,
OEM codes and ROM version are dis-
played. A ROM version displays three kinds,
application, boot, and IPL.
When the optional dual FAX is installed and
U698 set to [ALL], the ROM version for port
1 is primarily displayed.
9. After completing the installation, run the
communications test to confirm that the fax
system is operative.
Y108810-2
Code Destination
159 South Africa
169 Thailand
181 U.S.A.
242 South America
243 Saudi Arabia
253 CTR21 (European nations)
Italy
Germany
Spain
U.K.
Netherlands
Service Manual
Code Destination
253 Sweden
France
Austria
Switzerland
Belgium
Denmark
Finland
Portugal
Ireland
Norway
254 Taiwan
MAINTENANCE MODE
MAINTENANCE MODE ACTIVE.
Initialize: All Data
XXX
Country Code
OEM Code YYY
MAINTENANCE MODE
MAINTENANCE MODE ACTIVE.
Initialize: All Data
XXX
Country Code
YYY
OEM Code
APL
****************
BOOT
****************
IPL
****************
Figure 1-2-2
3KH-2
U600
U600
1-2-3