Gravely Pro-Stance 1934FX Owner's/Operator's Manual page 34

6. Repack bearings with clean grease.
7. Install bearings (E) and wheel spacer (F) (if removed), and
new seals (D).
8. Install wheel assembly (C), cap screw (B) and locknut (A).
9. Use a grease gun to fill hub until grease just appears at one of
the seals (D).
10. Lower machine.
Cleaning and Repairing Plastic Surfaces
Your authorized dealer has the professional materials needed to
properly remove surface scratches from any plastic surfaces, do
not attempt to paint over marks or scratches in plastic parts.
IMPORTANT: Avoid Damage! Improper care of machine
plastic surfaces can damage that surface:
Do not wipe plastic surfaces when they are dry. Dry wiping
will result in minor surface scratches.
Use a soft, clean cloth (bath towel, diaper, automotive
mitt).
Do not use abrasive materials, such as polishing
compounds, on plastic surfaces.
Do not spray insect repellent near machine.
1. Wash surface with clean water and a mild liquid automotive
washing soap.
2. Dry thoroughly to avoid water spots.
Cleaning and Repairing Metal Surfaces
Cleaning:
Follow automotive practices to care for your vehicle painted metal
surfaces. Use a high-quality automotive wax regularly to maintain
the factory look of your vehicle's painted surfaces.
Repairing Minor Scratches (surface scratch):
1. Clean area to be repaired thoroughly.
IMPORTANT: Avoid damage! Do not use rubbing compound
on painted surfaces.
2. Use automotive polishing compound to remove surface
scratches.
3. Apply wax to entire surface.
Repairing Deep Scratches (bare metal or primer
showing):
1. Clean area to be repaired with rubbing alcohol or mineral
spirits.
2. Use paint stick with factory-matched colors available from your
authorized dealer to fill scratches. Follow directions included
on paint stick for use and for drying.
3. Smooth out surface using an automotive polishing compound.
Do not use power buffer.
4. Apply wax to surface.
GB - 34