Components That Become Worn; Bearings And Bushings; Table 3 Components That Become Worn; Table 4 Bearings And Bushings - Milnor MWF63C Series Maintenance Manual

Table 2 Filters, Screens, and Sensitive Components (cont'd.)
Mark
Do this each
1 2 3 4 5 6
x
200 hours
x
200 hours
x 2400 hours
3.1.1.3

Components that Become Worn

Examine these items. Tighten or replace the item if necessary, to prevent shutdowns and un-
satisfactory performance. Speak to your dealer for replacement parts.
Table 3. Components that Become Worn
Mark
Do this each
1 2 3 4 5 6
x
200 hours
x
200 hours
x
200 hours
x
1200 hours
x
200 hours
x
200 hours
3.1.1.4

Bearings and Bushings

Unless the item is sealed, apply grease to prevent damage. See the next section for motors.
Table 4. Bearings and Bushings
Mark
Do this each
1 2 3 4 5 6
Grease plate 01 10025Z for bearing housing. Use this data if your machine has this grease plate. See
and Section 3.1.5 : Procedures for Bearing Components Connected to a Grease Plate, page
x
200 hours
x
200 hours
x
200 hours
x
200 hours
x
200 hours
x
200 hours
x
600 hours
Pellerin Milnor Corporation
Component
strainer for steam inlet.
(Steam is optional on
some models.)
speed sensor photoeye.
Optional on some models.
proximity switches
BNUUUH01.R12 0000399389 A.5 A.26 A.23 11/16/21 11:00 AM Released
Component
drive belts and pulleys
tubes and hoses (non-
hydraulic)
tilt air bags
door bumpers
rubber springs
shock absorbers
Component
side panel on some models, to access this grease plate.
seal
rear bearing
front bearing
Other Grease Ports
door hinge
door latch plunger
door open plunger
motor and pump bearings See
More Data. See also
See Figure 14, page 29
See Figure 18, page 32
See Figure 19, page 32
More Data
See Section 3.2.1 , page 24
Examine hoses and hose connections for leaks.
See Figure 17, page 31
Replace if damaged.
See Figure 23, page 36
See Section 3.3.3 , page 35
BNUUUH01.R13 0000399388 A.5 A.26 11/16/21 11:04 AM Released
More Data . See also
21. It is necessary to remove a
Add 0.06 oz. (1.8 mL) of grease EPLF2
20)
Add 0.12 oz. (3.6 mL) of grease EPLF2
Add 0.12 oz. (3.6 mL) of grease EPLF2
Figure 21, page 34. Add 0.12 oz (3.6 mL) of grease
EPLF2 (Table 8, page 20).
Figure 21, page 34. Apply stick DE3
to surface.
Figure 21, page 34. Apply stick DE3
to surface.
Section 3.1.6 : Procedures for Motors, page 21
Routine Maintenance
Section 3.1.2 , page 18
Section 3.1.3 , page 19
Figure 20, page 34
(Table 8, page
(Table 8, page 20)
(Table 8, page 20)
17