Yamaha Vstar XVS650T 2004 Owner's Manual page 79

1. Bolt
2. Final gear case
7. Lift the rear wheel off the ground
according to the procedure on
page 6-33.
8. While supporting the drive shaft,
pull the rear wheel back to remove
the following parts as an assem-
bly: wheel, wheel axle, final gear
case, and drive shaft.
NOTE:
Make sure to support the drive shaft as
it is being pulled out.
PERIODIC MAINTENANCE AND MINOR REPAIR
To install the rear wheel
1. Install the rear wheel, wheel axle,
final gear case, and drive shaft by
pushing the wheel forward and
guiding the drive shaft into the mid-
dle gear universal joint.
1. Middle gear universal joint
2. Drive shaft
2. Install the final gear case bolts.
3. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
4. Install the brake torque rod bolt
and nut at the brake shoe plate.
5. Install the panel.
6. Lower the rear wheel so that it is
on the ground.
6-36
EAU25511 7. Tighten the axle nut, the final gear
case bolts and the brake torque
rod nuts to the specified torques.
Tightening torques:
Axle nut:
92 Nm (9.2 m·kgf, 67 ft·lbf)
Final gear case bolt:
74 Nm (7.4 m·kgf, 54 ft·lbf)
Brake torque rod nut:
20 Nm (2.0 m·kgf, 14 ft·lbf)
8. Adjust the brake pedal free play.
(See page 6-22.)
WARNING
After adjusting the brake pedal free
play, check the operation of the
brake light.
EWA10660
6