Advertisement
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
Attaching the Handle
CAUTION! The Handle Socket will be held
down by a plastic block under tension. Wear
ANSI-approved safety goggles before freeing
Handle Socket. Hold Handle Socket down while
removing block. After removal, carefully swing
Handle Socket up until tension is released.
Bleeding
1. Loosen the Fill Screw.
2. Insert the Handle into the Handle Socket
to operate the Release Valve.
3. Turn the Handle counterclockwise to open the valve.
Adding Oil
1. Remove Fill Screw and Screw simultaneously,
see Figure B: Hydraulic Unit.
2. Add high grade hydraulic fluid into the Fill Screw
slowly until the oil reaches the top of the oil fill hole.
Page 4
For technical questions, please call 1-888-866-5797.
1. Fasten the Upper Handle to the Lower Handle.
2. Loosen the Set Screw and insert the
assembled Handle into the Handle Socket.
3. Tighten the Set Screw.
4. Pump the Handle up and down quickly several
times to purge air from the system.
5. Tighten the Fill Screw.
Note: Do not touch the Handle when
adding the hydraulic oil.
3. Replace the Fill Screw and Screw.
Item 64545
Advertisement
