Outland Living MAIN STREET Owner's Manual page 21

SECTION 4: EXTINGUISHING THE APPLIANCE
STEP 1
Access the Fire Table interior. Turn the gas cylinder valve to the 'Closed' position.
STEP 2
Turn the gas knob on the Fire Table to the 'OFF' position by pushing and turning the knob clockwise.
STEP 3
Allow unit to cool for at least five (5) minutes before relighting.
NOTE: Never use a lid or cover to extinguish the flame on your Fire Table.
SECTION 5: FIRE TABLE MAINTENANCE
Your Outland Fire Table requires periodic maintenance to keep it in good running order. Follow the steps below to ensure your appliance
will provide you with the best possible performance:
1. Keep your Fire Table out of the rain and store it in a dry place. Fire Table accessories such as covers can be purchased at
www.outlandliving.com or by calling 888-514-1663.
2. Always inspect and clear all valve and gas orifices of any foreign debris including spider webs prior to lighting. If any doubt there may
be a nest inside, use a pipe cleaner up the tube. See section 'REMOVING INSECT NESTS'.
3.
Clean any plugged burner orifices with a small paper clip.
4.
Periodically remove the igniter cover and clean the igniter tip and thermocouple tip of any carbon buildup using a damp rag.
5. Your glass rocks may crack and turn brown and black under normal operating conditions. This does not affect the functionality of your
fire table. The glass rocks can be washed clean.
6. If carbon deposits are noticeably forming on your glass rocks this usually indicates a lack of oxygen. Check to see the burner tube
venturi opening is wide open (where the burner tube meets the gas valve). Adjust glass rocks away from the burner tube holes.
7. This device has been engineered to provide the maximum amount of heat and comfort. If you experience any signs of your propane
cylinder 'freezing off' or start to experience lower flames than usual, please simply turn the burner control setting to low for 5–10
minutes, or replace the cylinder with a full one.
8. Ensure that you clean the top of your Outland Fire Table after every use to keep it looking GREAT. Simply use a damp cloth to wipe
down your Fire Table to keep it clean. Do not use abrasive cleaners. Especially, DO NOT USE PETROLEUM BASED SOLVENTS TO
CLEAN YOUR FIRE TABLE AS THIS WILL DESTROY YOUR WICKER RESIN TABLE MATERIAL.
9. Remove any debris and leaves which may have accumulated in your Fire Table burner tray before igniting.
ATTENTION:
It is normal for your burner tray to tarnish during regular operation. The surface tarnish on the stainless steel appears as a rusty-dark
brown and gold-yellow color (it is not rust!). The tarnish is caused by the heat of the flame and can be removed by using standard
stainless-steel cleaning products (we recommend a product called "Barkeeper's Friend"). Use a non-abrasive pad to wipe in the
direction of the grain of the stainless-steel (do not wipe in a circular motion, or against the grain, or scratches may appear). With a little
'elbow grease', the surface tarnish can be removed.
1-888-514-1663 | WWW.OUTLANDLIVING.COM
En-20