Programming; Loudmouth ™ Field Programming Overview - Ritron Jobcom J Series J-U410 Owner's Manual

3
For most installations the Loudmouth
need for Ritron PC Programmer 12.0.1. Field programming is accomplished in 3
easy steps. First, the radio frequency and tone codes are entered. Second, the
selective signaling code is entered (if used). Third, the Loudmouth
volume setting are entered.
3.1
Loudmouth
Use PROGRAM
Place the
Loudmouth button to scroll to
receiver one of the following
into Program Code
Program characters:
mode. [F], [C], [A], [U], [d]
Program
Codes Table Codes
Enter a 2-digit Frequency code from Table 1 and a 2-digit QC code from Table 2 or
Enter a 2-digit Frequency code from Table 1 and a 3-digit DQC code from Table 3.
Enter a 2-digit, 2-Tone Paging code from Table 4 or
Enter any 3 – 7-digit Selcall Paging Code.
Enter a 2-digit Loudmouth
•
Enable or disable a Pre-Announce Tone.
•
Enable or disable Record and Play operation.
•
Enable or disable Weather Alert feature (VHF models only)
•
Enable or disable Battery Powered Operation.
•
Enable or Disable Power Save operation.
•
Reset Loudmouth to Factory default programming.
Enter the desired Speaker Volume Level as a 2 –digit number from 05 – 99.
Enter the 1-digit NOAA Weather Frequency code from Table 6 (VHF models only)
This only programs the NOAA weather frequency, the Weather Alert feature must be enabled using
the Special Features code in Table 5.
13

Programming

™
Field Programming Overview
Pause, a
hyphen
will
appear
on the
display.
™
Feature code from Table 5 to:
Section 3
™
can be programmed in the field without the
Using the
PROGRAM
button,
enter the
desired
Table Code.
Programming
™
options and
Press ENTER button to save
programming entry.
Press ENTER button a second
time to Exit programming.
or
Proceed with next program entry.