Table of Contents
Advertisement
Fitting the Floor Tool
The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor tool gets snagged, whilst in transit.
Note: The lever moves upward and backward motion to lock the floortool in the raised position.
Note: It is easier to fit the floor-tool if the weight of the machine is resting on the brush.
9
Filling the clean-water tank
10
Note: Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc)
are not allowed to enter the clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean and free from debris.
Machine Set-Up
The floor tool carrier can be
raised and locked from moving
by operating the locking lever,
upwards and backwards.
This lever can be found next to
the lower section of the handle.
Unlock and swing the floor tool
carrier to the side of the machine
(Fig 8).
Ensure the brush is fitted first.
Secure to the carrier using the
two knobs fitted to the floor tool
carrier (Fig 9) - (Fig 9a).
Do not over tighten the retaining
knobs.
The TT1840 is equipped with
a large 18 litre clean water
tank allowing large areas to be
cleaning in a single fill.
To fill the clean water tank,
remove the filler cap (Fig 10).
Fill using a hose, bucket or a
suitable container. (Fig 11).
8
8
9a
11
Advertisement
Table of Contents
