Changing The Floor-Tool Blades; Refitting The Floor Tool Blades - Numatic TT 516 Original Instructions Manual

!
ALWAYS ENSURE THAT THE POWER SUPPLY IS DISCONNECTED PRIOR TO ANY
Unscrew the four knobs securing the blade holder (Fig 43).
Remove the blade holder (Fig 44).
Replace the Squeegee blades using (606261) replacement blade set (Fig 45), fitting the blades on to the moulded
location lugs.

Refitting the Floor Tool Blades

1. Floor-tool main body
2. Blade carrier
3. Rear blade
4. Front blade (slotted)
5. Retaining Knobs x 4
Use Genuine NUMATIC spare parts.
Replacement Blade Set (606261)
Fig 41
Fig 43
Fig 46
use

Changing the Floor-Tool Blades

MAINTENANCE.
To change the floor-tool, firstly swing the floor-tool clear of the
machine (Fig 41).
Undo the two floor-tool retaining knobs (Fig 42).
Fig 42
Refit the blade holder, retain using the two outer knobs
(Fig 46)
Ensure the slotted blade goes to the front of the
floor-tool (Fig 47).
Note:
The blades are designed to be reversible, thus
Refit the floor-tool using the two central knobs to
the floor-tool.
Fig 47
1
2
3
4
22
Fig 44
extending their useful working life.
Refer to Page 5 for fitting instructions.
5
!
Fig 45