To Select Pool Or Spa Mode; To Increase The Desired Water Temperature (Pool Or Spa Mode); To Select Temperature In °C Or °F - Raypak 6350 Series Installation & Operating Instructions Manual

Digital Controls Operating
Instructions
The electronic board has the capability of memorizing
two different programmed temperature settings as fol-
lows (refer to Fig. 5):
• For a pool, maximum 95°F (35°C)
• For a spa, maximum 104°F (40°C)

To Select Pool or Spa Mode

To have access to either one of these programs, press
the SET key until you see P _S and by pressing the
UP or DOWN key you can switch to POL or SPA.
To Increase the Desired Water
Temperature (Pool or Spa Mode)
Push the SET key until you see POL or SPA. The pro-
grammed temperature will be displayed. Press the UP
arrow to increase the temperature setting one degree
at a time.
To Lower the Desired Water
Temperature (Pool or Spa Mode)
Push the SET key until you see POL or SPA. The pro-
grammed temperature will be displayed. Press the
DOWN arrow to decrease the temperature setting one
degree at a time.
Once the control has been programmed to the desired
pool water temperature, the programmed temperature
will be displayed for approximately 5 seconds. Then
the digital display will display the actual pool water
temperature.
To make the Board a Pool ONLY Board, call 800-
260-2758 for instructions.
To Select Temperature in °C or °F
Press the SET key until you see F _C. By pressing the
UP or DOWN key you can switch to °F or °C. Once the
temperature display mode has been programmed it
will be displayed for approximately 5 seconds, then
the digital display will return to the actual pool water
temperature in the mode that you have chosen.
Heat/Cool Operation (Models
6350HC and 8350HC Only)
The heat/cool model is designed to both heat and cool
the pool. To select heat or cool mode, push the SET
key until H/C is displayed. Press the DOWN arrow key
to select heating (hea), or the UP arrow key to select
cooling (col). Set the desired setpoint temperature as
described earlier in this manual.
NOTE: Once the control has been programmed to
the desired pool water temperature, the pro-
grammed temperature will be displayed for
approximately 5 seconds. The digital display will
then show the actual pool water temperature.
NOTE: Remove the pool/spa blanket and turn on
any fountains, sprays or other water features to
speed cooling.
When the unit has been operating in the heating mode
for a few minutes, the discharge air temperature
should be 8°–10°F cooler than the air entering the unit.
When the unit has been operating in the cooling mode
for a few minutes, the discharge air temperature
should be 8°–10°F warmer than the air entering the
unit.
NOTE: Heating is more efficient during warmer day-
light hours and cooling is more efficient during cooler
night time hours.
12