Rimage Amigo II Hardware Manual page 3

8. If the disc is not aligned to the bins, adjust the lift
arm.
•
To adjust the lift arm right or left:
a. Remove the disc from the gripper.
b. Loosen the Torx T15 screw located on the
bottom of the gripper board assembly.
c. Grip the disc release button and slide the
gripper board assembly left or right as
necessary.
Tip: Use the screw and the gap as a
guide to how far you are moving the
gripper board assembly. See below.
d. Tighten the Torx T15 screw.
e. Repeat alignment check.
Screw and Gap
•
To adjust the lift arm front to back:
a. Leave the disc in the gripper and loosen
the Torx T10 screw.
Important! Keep the screwdriver in
position.
b. Gently move the lift arm forward or
backward.
c. While holding the lift arm in position, tighten
the Torx T10 screw.
d. Repeat alignment check.
112161_B © 2007, Rimage Corporation
Producer Family
Left to Right Adjustment
Disc Release Button
Front to Back Adjustment
Torx T10
Screw
3