introduction
Back
➊
Power input terminal : Connect the power as specified for each model here.
➋
MD Output Terminal : Motion detection signals are output through this terminal.
➌
RS-485 control terminal : You can control SETUP MENU through this port by using
➍
Video output terminal : Video signals are output through this port. Connect this port
M
Connector
MD(Motion Detection) Output format is open collector.
12_ introduction
external controllers like a Remote controller that RS-485
Communication is supported. For details, see page 16.
to the Video IN port of a monitor.
MD
There is no motion
❶
➋
➌
➍
Signal Level
USER Vcc
5±0.5sec
0V
There is motion
← →
I/O
Output