Advertisement
M S-7100 ATX M ainboard
OnBoard Sil3132 RAID
This setting controls the onboard Sil3132 RAID chip. Setting options: [Enabled],
[Disabled].
OnBoard Sil3132 Mode
This setting allows you to select the Onboard Sil3132 mode. Setting options: [SATA],
[RAID].
I/O Device Configuration
Press <Enter> to enter the sub-menu and the following screen appears:
Onboard FDC Controller
Select [Enabled] if your system has a floppy disk controller (FDD) installed on
the system board and you wish to use it. If you install add-on FDC or the system
has no floppy drive, select [Disabled] in this field. The settings are: [Enabled],
[Disabled].
COM Port 1
Select an address and corresponding interrupt for the first serial port. The
settings are: [3F8/IRQ4], [2E8/IRQ3], [3E8/IRQ4], [2F8/IRQ3], [Disabled], [Auto].
IR Function Select
This setting allows you to specify the operation mode for serial port 2. Setting
options: [IrDA], [ASKIR], [Disable].
[Disable]
[IrDA]
[ASKIR]
RxD, TxD Active
This setting controls the receiving and transmitting speed of the IR peripheral in
use. Setting options: [Hi,Hi], [Hi,Lo], [Lo,Hi], [Lo,Lo].
IR Transmission Delay
This setting determines whether the IR transmission rate will be delayed while
converting to receiving mode. Setting options: [Disabled], [Enabled].
3-12
RS-232C Serial Port
IrDA-compliant Serial Infrared Port
Amplitude Shift Keyed Infrared Port
Advertisement
