Rimage 480i Replacement Manual

Rimage Desktop Family™
Replace the Printer Platform on a Rimage 2000i or Standalone 480i Printer
Use this procedure to replace the printer platform on a Rimage 2000i™ or Standalone 480i™ Printer.
Rimage approved parts must be used for this process. The product warranty may become void if parts not approved by Rimage are
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
Note: Your system may not look exactly like the system pictured.
Before you begin
1. Stop or pause all jobs.
2. If the printer is on an autoloader, power off the
autoloader.
3. Disconnect the power cord from the power outlet.
Remove the Printer Platform
1. Disconnect the cables.
Caution! Some cables in this system are latched. Equipment damage may occur if cables are not
disconnected appropriately.
•
FireWire ca ble (if present, 2000i only)
•
USB cable
•
Power cord
2000i
2. Open the printer service door.
Tip: Press the tab to free the printer service
door from the frame.
3. Remove the rear Torx T10 screws (Qty. 2) from
the printer platform.
Note: The printer platform is the metal plate
on top of the sliding printer tray.
2000558_B
Required tools:
•
Torx T10 screwdriver
USB Cable
Printer
Service
Door
USB Cable
FireWire
Cable
Power
(if present)
Cord
Powe r
Cord
Printer
Servic e
Door
Printer
Platform
© 2007, Rimage Corporation
Standalone 480i Printer
Tab
Operator
Printer
Service
Door
Printer
Tray
1