Replacing The Pilot Orifice; Replacing The Igniter - Pentair MagicFlame 580165 Installation And User Manual

Fire and water bowl
Table of Contents

Advertisement

17

REPLACING THE PILOT ORIFICE

The pilot orifice is located at the base of the pilot/igniter assembly and
the burner orifice is located at the end of the main burner pipe.
Each orifice is specific for either Natural Gas or Propane.
1. Turn off the electrical and gas supply to the fire feature.
2. Remove fire media from the bowl.
Fire media may still be hot after the fire feature is shut off.
To prevent personal injury, ALWAYS allow the fire media to
cool before redistributing. Depending on the size of the bowl, cooling may take
up to an hour.
3. Remove the two mounting screws securing the pilot/igniter assembly to the support
plate. See FIGURE 10.
4. Lift the burner assembly from the bowl and turn it over to access the underside
components.
5. Unplug the connector from the control box. See FIGURE 11.
6. Disconnect the flexible pilot gas hose from the control box.
See FIGURE 12.
7. From the top of the burner support plate, pull up and
remove the pilot/igniter assembly. See FIGURE 13.
8. Remove the Flare Fitting from the Pilot Orifice and remove
the Pilot Orifice from the support bracket. See FIGURE 14.
9. Install the new Pilot Orifice in reverse order.

REPLACING THE IGNITER

1. Turn off the electrical and gas supply to the fire
feature.
2. Remove fire media from the bowl.
Fire media may still be hot after the
fire feature is shut off. To prevent
personal injury, ALWAYS allow the fire media to cool
before redistributing. Depending on the size of the bowl,
cooling may take up to an hour.
3. Remove the two mounting screws securing the
pilot/igniter assembly to the support plate. See
FIGURE 10.
4. Lift the pilot/igniter assembly and expose the
connector.
5. Unplug the connector from the control box. See
FIGURE 11.
6. Remove the pilot hood. See FIGURE 14.
7. Remove the mounting screw securing the Igniter and remove the damaged
igniter. See FIGURE 15.
8. Mount the new igniter assembly to the support plate, ensuring the slotted side
of the pilot hood is facing the burner. See FIGURE 13.
MAGICFLAME™ Fire and Water Bowl Installation and User' s Guide
FIGURE 10
FIGURE 12
FIGURE 14
FIGURE 15
FIGURE 11
FIGURE 13

Advertisement

Table of Contents
loading

Table of Contents