Bowl Installation - Pentair MagicFlame 580165 Installation And User Manual

Fire and water bowl
Table of Contents

Advertisement

11

BOWL INSTALLATION

Water Bowls:
Water bowls must be leveled, centered or placed in the
desired position and secured to the mounting surface.
Once this is complete, the center hole must be sealed
and filled in such a way that water will not leak through
the water inlet pipe and onto the mounting surface.
Water bowls typically are permanently adhered to its
mounting surface. Water bowls must be secured and
sealed to the mounting surface using a sealing adhesive
and not the mounting method described below.
Fire and Fire/Water Bowls:
Stub-outs should be centered so that the bowl can be
permanently installed in the desired position.
Although there is a center hole in the bowl bottom, any
off centered stub-outs may require cutting the bottom
of the bowl in order to fit properly onto the mounting
surface.
To install the bowl:
1. Ensure the desired mounting surface is level and
allows for recommended vertical and horizontal
clearances.
Note: Minimum vertical clearance of 6 ft [1.8
m] above the burner. Minimum side to side
clearance of 4 ft [1.2 m].
2. Place the bowl over the electrical, gas, bonding
wire and water stub-outs.
3. Ensure the bowl is centered and the front edge of
the bowl scupper extends into the pool or body of
water by 3 inches [7.6 cm].
4. Looking down into the bowl, mark four points for
feature support feet. See FIGURE 4.
FIGURE 4
MAGICFLAME™ Fire and Water Bowl Installation and User' s Guide
5. Using a 3/8-inch concrete drill, drill down a
minimum of 4 inches [10.2 cm] at all four marked
locations. See FIGURE 5.
FIGURE 5
6. Install a single anchor bolt until flush with the bowl.
Note: Do not over-tighten or strip the anchor
bolts.
7. Gently ensure the bowl is tightly secured to
the mounting surface and can not be rocked or
lifted.
Any offset will cause the bowl to crack when the
next three anchors are being secured.
8. Repeat the anchoring process for each mounting
location.
9. Ensure the bowl is firmly secured to the surface.
The bowl should not tip, rock or otherwise move in
any way.
FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN PROPERTY DAMAGE,
PERSONAL INJURY, OR DEATH.
Be aware of the risk of high surface temperatures
and stay at a safe distance to avoid burns or
clothing ignition.
DO NOT allow children to play on or around the
fire feature or any associated equipment.
ALWAYS closely supervise young children when
around this product or pool.
DO NOT stand, sit, or hang on the fire bowl.

Advertisement

Table of Contents
loading

Table of Contents