Table of Contents
Advertisement
Re-Key Every 1G of Traffic
Server
Environment
Commands
TTY
Proxy
Type
Host
Port
User
Password
Network
Network Keep Alive
Detect out of Range
Connect Timeout
Barcode Settings
Configuration
Debug
Generate Log
method ensures the key is exchanged only upon per gigabyte of
transmitted data or per hour of connection time, whichever occurs
sooner. Enable these options to trigger TE to exchange a new key
with the server every 60 minutes or following a total data flow of 1
Gigabyte in either direction.
Specifies environment variables to be set on the SSH server.
Represent a special command or subsystem to invoke on the SSH
server in lieu of an interactive shell. This is typically used for
non-interactive host sessions. For most users this will be blank.
This setting can be used to add TTY Modes to be sent to the SSH
server.
Tap to configure what type of proxy you want CL TE to use for its
network connections.
Tap to specify the DNS name or IP address of the proxy server. The
default is blank.
Tap to specify the port on which the proxy server is listening. Set
this to match the port on the proxy server for connections.
If your proxy server requires authentication, enter the username.
The default is blank.
If your proxy server requires authentication, enter the password.
The default is blank.
Tap to enable/disable sending a thread to the host according to the
time interval to make sure it's connecting to the host.
Tap to enable/disable detecting if the device is out of network
range.
Tap to establish a time period within a connection with the server.
Tap to proceed with related settings. Please refer to the device user
manual.
Tap to determine whether to generate log.
2 User Interface
15
Advertisement
Table of Contents
