Ricoh AP2610 Setup Manual page 34

Installing Options
E E E E
Pull out the handle of the control-
ler board.
2
F F F F
Pull the handle and slide the con-
troller board out.
G G G G
Place the controller board on a flat
surface.
H H H H
Use a coin to remove the two
screws, and then remove the cover.
Note
❒ These screws are used again in
J
step
❒ The removed cover is not used
when installing the Network In-
terface Board.
22
.
I I I I
Insert the end of the Network In-
terface Board into the opening
(A A A A ), and then push down until it
clicks (B B B B ).
ZGDX370J
ZGDX261J
J J J J
Fasten the Network Interface
Board to the controller board.
ZGDX410J
ZGDX422J
ZGDX432J
ZGDX441J