Envelope Feeder Type 2600 - Ricoh AP2610 Setup Manual

Envelope Feeder Type 2600

Note
❒ This unit is a tray that slides into
the optional Paper Feed Unit.
Without the optional Paper Feed
Unit, this Envelope Feeder cannot
be used.
❒ Your printer can have two optional
Paper Feed Units. However, the
Envelope Feeder must be used in
the top-most optional Paper Feed
Unit (Tray 2). It cannot be used in
the bottom-most optional Paper
Feed Unit (Tray 3).
Important
❒ Do not slide more than one paper
tray out at the same time. Having
more than one paper tray filled
with paper in a fully extended po-
sition could cause the machine to
fall down.
A A A A
Check the contents of the box for
the following items:
• Envelope Feeder
• Installation Guide
B B B B
Pull out the second paper tray
(Tray 2) of the optional Paper
Feed Unit until it stops. After that,
lift it slightly, and then pull it out.
Important
❒ The Envelope Feeder must be
used in the top-most optional
Paper Feed Unit (Tray 2).
❒ The tray of the top-most option-
al Paper Feed Unit is beneath
the paper tray.
Note
❒ Keep the paper tray with paper
in a cool dark place.
C C C C
While lifting the front side of the
Envelope Feeder, place the feeder
into the printer. Then slide it into
the printer until it stops.
Reference
For information about loading pa-
per, see "Loading Envelopes" in the
Printer Reference on the CD-ROM
labeled "Operating Instructions".
ZDDP330E
Envelope Feeder Type 2600
ZDDP340E
2
17