Fujitsu DL7400 Maintenance Manual page 94

(47) DV Roller ASY replacement
Removal
1. Remove the upper cover.
2. Remove the printer mechanism assembly.
3. Remove the LF bracket (one screw) and LF belt.
4. Remove the two flanges (two E-rings), two DV gears, two nip gears (two E-rings), and one platen gear (one
E-ring) from the left of the mechanism assembly.
5. Remove the slide cam and OC cam from the left side of the mechanism assembly.
6. Remove the bearings from the left side of the mechanism assembly.
7. Remove 3 e-rings, 2 flanges and slide cam at right side of printer mechanism.
8. Remove the OC cam and bearing at right side of printer mechanism.
9. Remove 4 screws fixing lower guide at left and right side.
Figure 4.66 Removing DV Roller
Figure 4.67 Removing DV Roller
94