Fujitsu DL7400 Maintenance Manual page 91

7. Turn down the mechanism assembly.
8. Disconnect cables backside of printer mechanism unit, remove 6 screws of lower plate.
9. Remove the bearings and slide in the direction of allow then remove it.
Platen roll
Screws for lower plate
Note:
Take care of jamming cables together when install platen cover.
Figure 4.63 Removing the Platen roll
Installation
1. Assembly by reverse order the removal.
Note Lubrication is necessary to right and left shaft of Platen roll.
(Refer to lubrication tables)
91