ELRO CCD420 - CCD Dome Camera Manual
![]()
SPECIFICATIONS
Image sensor | 1/4" SHARP colour CCD |
Lens | 3,6mm angle 72,5° |
Pixels | 500x582 |
Signal System | PAL/NTSC |
Resolution | 420 lines |
Minimum illumination | 0.8Lux |
Turnable dome: | H58°, V40° |
Video output | 1.0Vp-p, 75O, Composite |
Power requirement | DC12V |
Operating temperature | -10°C ~ +50°C |
Cable | 18+2m |
CCD420 CCD DOME CAMERA
Because of its properties, this CCD camera can be used practically anywhere indoors. The plastic housing protects the camera against dust and destruction. The camera can be mounted on the ceiling as well as on the wall. Because of the CCD sensor, the sharpness and colour of the image are perfect. Installation is simple. Using a RCA or BNC connector, the camera can be connected to a video jack of a TV, VCR, DVR, etc. Please read the entire user manual before starting the installation/mounting!
CONTENTS
![ELRO - CCD420 - CONTENTS CONTENTS]()
- Dome Camera.
- Power adapter
- Extension cable
- RCA(cinch) -BNC adaptor
INSTALLING THE CAMERA
- Open the plastic dome by turning 1cm to the left until it stops (2).
![ELRO - CCD420 - INSTALLING THE CAMERA - Part 1 INSTALLING THE CAMERA - Part 1]()
- Remove the plastic cover (3).
![ELRO - CCD420 - INSTALLING THE CAMERA - Part 2 INSTALLING THE CAMERA - Part 2]()
- Use 2 screws to fasten the assembly plate on the desired location (4).
![ELRO - CCD420 - INSTALLING THE CAMERA - Part 3 INSTALLING THE CAMERA - Part 3]()
CONNECTING THE CAMERA
- Connect the camera (1a) with extension cable (1c) to the AV equipment if necessary by using the RCA(cinch)-BNC adapter (5).
![ELRO - CCD420 - CONNECTING THE CAMERA - Part 1 CONNECTING THE CAMERA - Part 1]()
- Connect the camera (1a) with extension cable to the power adaptor (6).
![ELRO - CCD420 - CONNECTING THE CAMERA - Part 2 CONNECTING THE CAMERA - Part 2]()
- Select the AV input on the recording/viewing device.
CAMERA TUNING
- Slightly loosen the screw of the base plate (7) and Point and turn the camera to the desired position.
![ELRO - CCD420 - CAMERA TUNING - Part 1 CAMERA TUNING - Part 1]()
- Fasten the screws of the base plate again.
- Make sure that the transparent opening stays in front of the camera lens (8).
![ELRO - CCD420 - CAMERA TUNING - Part 2 CAMERA TUNING - Part 2]()
- To close the dome, place the cover and turn it 1cm to the right.
TIPS
- When there is insufficient night view an auxiliary IR spot can be used like the CS17.
- This dome camera is intended for indoor use, not for outdoor use. Even when sheltered, we advise you to use a waterproof outdoor camera.
![]()
![]()
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download ELRO CCD420 - CCD Dome Camera Manual
Need help?
Do you have a question about the CCD420 and is the answer not in the manual?
Questions and answers