Beko WTE 7531 X0 User Manual page 6

Table of Contents

Advertisement

Available languages

Available languages

2. Remove transportation safety bolts by turning them
gently.
3. Attach the plastic covers supplied in the User
Manual bag into the holes on the rear panel. (P)
C
NOTE :
Keep the transportation safety bolts in
a safe place to reuse when the washing machine
needs to be moved again in the future.
NOTE :
Never move the product without the
transportation safety bolts properly fixed in place!
2.4 Connecting water supply
C
NOTE :
The water supply pressure required to run
the product is between 1 to 10 bars (0.1 – 1 MPa). It
is necessary to have 10 – 80 liters of water flowing
from the fully open tap in one minute to have your
machine run smoothly. Attach a pressure reducing
valve if water pressure is higher.
A
WARNING:
Models with a single water inlet
should not be connected to the hot water tap. In
such a case the laundry will get damaged or the
product will switch to protection mode and will not
operate.
WARNING:
Do not use old or used water inlet
hoses on the new product. It may cause stains on
your laundry.
6 / EN
1. Tighten all hose nuts by hand. Never use a tool
when tightening the nuts.
2. Open the taps completely after making the
hose connection to check for water leaks at the
connection points. If any leaks occur, turn off the
tap and remove the nut. Retighten the nut carefully
after checking the seal. To prevent water leakages
and damages caused by them, keep the taps closed
when the machine is not in use.
2.5 Connecting to the drain
• The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
A
CAUTION:
Your house will be flooded if the hose
comes out of its housing during water discharge.
Moreover, there is risk of scalding due to high
washing temperatures! To prevent such situations
and to ensure smooth water intake and discharge
of the machine, fix the end of the discharge hose
tightly so that it cannot come out.
• The hose should be attached to a height of at least
40 cm, and 100 cm at most.
• In case the hose is elevated after laying it on the
floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more
difficult and the laundry may come out excessively
wet. Therefore, follow the heights described in the
figure.
Washing Machine / User's Manual

Advertisement

Table of Contents
loading

Table of Contents