Huawei EchoLife EG8041V5 Quick Start Manual page 8

EchoLife EG8041V5
Quick Start for QR code
No.
1
2
3
4
5
6
7
Issue 01 (2022-09-15)
NO TE
● The fiber connector connected to the optical port on the wall varies depending on
actual conditions.
● To ensure normal use of fibers, make sure that the fiber bending radius is larger than 30
mm.
Item Description
On/Off Powers the ONT on or off.
Power Connects to a power adapter.
LAN1- Connects to PCs or IP set-top boxes (STBs).
LAN4
Reset Press the button for a short time to reset the device; or
press the button for a long time (longer than 10s) to
restore the device to the default settings and reset the
device.
NOTE
WLAN Used to enable or disable the WLAN function.
- When the WLAN is disabled, press the WLAN button (>
3s) and release the button to enable the WLAN.
- When the WLAN is enabled, press the WLAN button (>
3s) and release the button to disable the WLAN.
WPS When the WLAN is on, press the WPS button (> 3s) and
release the button to start Wi-Fi protected setup (WPS)
negotiation.
Optical The optical port is equipped with a rubber plug and
port connected to a fiber for upstream transmission.
The type of the optical connector connected to the optical
port can be SC/APC.
Copyright © Huawei Technologies Co., Ltd.
Reset Huawei ONTs with caution. Otherwise, the ONTs may fail to
access the Internet. If an ONT cannot access the Internet after a
reset, contact your Internet service provider.
2 Connecting Cables
5