Post-Installation Check - Raymarine Universal IO Drive Install Manual

Universal I/O Drive - Installation Guide

4. Post-installation check

Type 150/400 course computer
– +
A
OFF
POWER MOTOR
SWITCH
blue
Figure 4: Connections at course computer
WARNING:
Keep clear of moving steering systems at all times. Protect
moving parts from access during normal use.
WARNING:
Only operate the autopilot system with the engines running and
power-assisted steering operating.
Check the following points after installing the drive:
1. Is the drive unit securely attached to the steering system (with all
brackets, bolts, split pins, etc. secure)?
2. Is the drive unit correctly aligned?
3. Are the motor and clutch cables correctly routed and securely
connected to the course computer?
4. Complete a hand-steering check: Are you sure there is no contact
between the drive unit and any part of the engine, steering system
or boat's structure when the push rod moves in and out?
Note: When you have installed the entire autopilot system, you will
need to complete an autopilot steering check. Refer to the control unit
handbook for more details.
– – – +
B
SOLENOID CLUTCH
black red
brown
Type 100/300 course computer
– + – +
lk CLUTCH POWER MOTOR
black red
blue
13
1 2
brown
D5184-2