Moving The Cursor - Raymarine SL72 Owner's Handbook Manual

Chapter 1: Overview
The cursor is used to:
• Select a position on the screen.
• Select an item, e.g.guard zone on the display.
• Select an area of the radar image to zoom into.

Moving the Cursor

You can press on any of the four sections of the trackpad to move the cursor in
that direction (up, down, left or right), or press two sections at the same time to
move diagonally. The cursor moves faster as you continue to press the
trackpad. The current cursor position is shown in the cursor data box (if
selected).
Note: During many operations you cannot move the cursor around the
screen; if you cannot move the cursor using the trackpad, check the default
soft keys are displayed (unless they have been switched OFF in system set up).
If not, press ENTER until they are displayed.
The cursor is normally displayed as a crosshair.
Context-Sensitive Cursor Control
The cursor is context-sensitive. When the cursor is positioned over special
features on the display a text label appears to identify the feature as follows:
Table 1-2:
Text Label
BOX
MOB
MRK
WPT
CTR
FLT
GRD
SHM
VRM/EBL
ZMB
➟
A
COG
HDG
Context-Sensitive Cursor Text Labels
B
Feature
Data box (any type)
Man Over Board marker
Radar Mark
Chart Waypoint
Centre of radar
Floating EBL/VRM
Guard zone
Ships Heading Marker
VRM and EBL, 1 or 2
Zoom box
Ruler line
Course Over Ground vector
Heading vector
Radar/Chart (SL72RC
PLUS only)
Both
Both
Both
Both
Radar
Radar
Radar
Radar
Radar
Radar
Chart
Chart
Chart
1-13