Beko 01M-8809143200-0722-16 User Manual page 15

5 Installation of appliance
5.5 Installation of the hood to the
flue
Make the electrical connection of your hood be-
fore starting the installation of the flue. Slip the
flue plates around the body. Screw the flue to the
flue fastening plates available on the motor cabin.
(Figure 8).
Install the flue to the flue fastening plate that is
secured to the wall from its upper outer edges
(Figure 8).
(Figure 8)
5.6 Installation of air baffle
While using with the carbon filter, air baffle is pro-
vided with your appliance with the aim of re-re-
leasing the air which is cleaned with carbon fil-
ter from the perforated located on the chimney.
Assemble the air baffle as below.
Cooker Hood / User Manual
(Figure 9)
There is a tab in the middle of the chimney con-
nection plate. Place the middle point of this tab on
the line that is drawn perpendicular to the wall.
Align horizontally and mark the holes where the
connection plate will be mounted via a pen (Figure
9/A, B).
Drill the marked points with Ø6mm drill and in-
sert two Ø6mm plastic dowels in the drilled holes
(Figure 9/A, B).
Fix the chimney connection plate to the wall with
3.9x22 screws (Figure 9/A, B).
For the assembly air baffle, drill points C, D, E, F
with a Ø6mm drill bit and tap the Ø6mm plastic
dowels (Figure 9).
Assemble cooker hood's body (Figure 5).
(Figure 10)
1. Flap Pin Socket
2. Flap Pin
15 / EN