Beko 01M-8809143200-0722-16 User Manual page 14

5 Installation of appliance
Attach the 150mm plastic chimney adapter in-
cluded in the package to the product body with
3.5x9.5 blunt-ended screws. If the air outlet is
to be connected to the air discharge duct smaller
than 150mm, install the 150 / 120mm plastic flue
adapter (Figrure 4).
(Figure 5)
Hold the cooker hood by its body and place it on
the mounting screws on the wall and tighten the
screws (Figure 5).
Secure the cooker hood with two 4.8x50 screws to
the wall through the mounting hole on the interior
of the appliance (Figure 5).
5.4 Connecting to flue
(Figure 6)
1. Flap pin socket
2. Flap pin
14 / EN
Insert the plastic pin (Figure 6/area no. 2) on the
pin socket on the motor exhaust (Figure 6/area
no.1). Then bend the flap lightly to insert the other
pin on the flap and insert the other pin to its socket
(Figure 6).
If you are going to use the Ø 120/150 mm plastic
flue adapter, connect one end of the pipe to this
adapter, if you are not going to use it, to the direct
output on the product. Connect the other end of
the pipe to your flue. Check that these two con-
nections are tight enough so they will not come out
when the appliance runs on full power. Ensure that
the flaps inside the flue work when tightened with
clamp. Connect the flue connection duct outside
the adapter (Figure 7/a). If the connection duct is
fitted inside the adapter, suction of air shall not
occur as the flue flap that prevents the return of air
will remain closed (Figure 7/b). The length of the
pipe connection as well as the number of elbows
must be as minimum as possible.
A : Flue exit pipe
B : Flue clamps
C: Plastic flue
The valves are closed then the appliance is not
operating and prevent possible outside odour and
dust from entering inside.
(a)
OK
(Figure 7)
Cooker Hood / User Manual
(b)
Not OK