Table of Contents
Advertisement
OPERATIONAL INSTRUCTIONS
USING THE FITNESS METER
POWER ON :
Bounce on the trampoline or press the button.
POWER OFF :
Automatically shuts off after four minutes of
inactivity.
MODE BUTTON:
Press to select lower display functions. Lower display functions
including SCAN, TIME, CALORIES, and STRIDES/MIN.
Press and hold for three seconds to reset all functions to zero.
FUNCTIONS:
COUNT :
Upper readout displays the total number of strides you have taken from zero to 9999
strides.
SCAN:
Automatically scans each function of TIME, CALORIES, and STRIDES/MIN in sequence
changing every six seconds. Press and release the button until the arrow appears on the
display and points to the SCAN.
TIME:
Displays the time from one second up to 99:59 minutes.
After four seconds of inactivity, the meter will automatically stop timing the workout.
Restart the meter by bouncing on the trampoline or press the button.
STRIDES/MIN:
Displays the rate of strides per minute.
CALORIES:
Displays the calorie burned from zero to 9999 Kcal.
The calorie readout is an estimate for an average user. It should be used only as a
comparison between workouts on this unit.
HOW TO INSTALL AND REPLACE BATTERIES:
1. Open the Battery Door on the back of the meter.
2. The meter operates with a AA battery (1.5V each), the battery is not
included. Refer to the illustration to install or replace the battery.
NOTE:
1. Rechargeable batteries are not recommended.
2. Ultimate disposal of battery should be handled
according to all state and federal laws and regulations.
3. Do not dispose of batteries in fire.
13
CNT
STRIDES
/MIN
TIME
SCAN
CAL
MODE
AA Batteries
Advertisement
Table of Contents
