Troubleshooting Guide - Dometic 2000 Series Owner's Manual

TRoubleShooTING GuIDe

DoMeTIC ToIleT
bASe ASSeMbly
peDAl
CoveR
ToIleT boWl, ReAR vIeW
(Models 510+, 511+, 2010, 2011)
vACuuM
bReAKeR
vACuuM bReAKeR/boWl CoNNeCTIoN
problem
1. Toilet emits odor (flush ball
open).
2. Water will not stay in bowl.
3. Flush ball will not close
completely.
® Pledge is a registered trademark of S.C. Johnson & Son Inc.
ADJuSTING NuT
CAM STRAp
WATeR vAlve ASSeMbly
Top vAlve CAp
fIlTeR SCReeN
vAlve boDy
WATeR vAlve SCReWS
WhITe CAp
hoSe
CoNNeCTIoN
possible Cause
a. Odor emitting from base of toilet.
b. Plugged holding tank vent line.
a. Loose band clamp.
b. Improper seal around flush ball
due to dirt or debris on flush ball.
c. Worn or damaged seal.
d. Worn or damaged flush ball.
a. Too much friction between flush
ball and seal.
b. Water valve screws are too tight.
c. Defective spring cartridge.
ShAfT
SpRING
CARTRIDGe
MoDel 111 ToIleT boWl, ReAR vIeW
vACuuM
bReAKeR
vACuuM bReAKeR/boWl CoNNeCTIoN
Service Instructions
a. Use SeaLand brand deodorants.
b. Clear obstruction from vent line.
a. Tighten adjusting screw.
b. Inspect flush ball and seal for
foreign debris. Clean flush ball
and seal if needed.
c. Replace seal.
d. Replace flush ball.
a. Lubricate between flush ball and
seal with furniture polish (e.g.
Pledge
b. Loosen screws slightly.
c. Check spring tension by pushing
flush lever down, then release it
suddenly. If lever does not snap
back to original position, replace
spring cartridge.
6
bAll SeAl
boWl SeAl
bAND ClAMp
fluSh bAll
hoSe
CoNNeCTIoN
furniture polish).
®