Setting Memory Channels; Accessing Memory Channels - Midland G15 GMRS Portable Owner's Manual

SETTING MEMORY CHANNELS

"
There are 9 memory channels available.
To set Memory Channels
1. Press the "F" button repeatedly until the "M" is displayed above the flashing
memory channel number in the lower left of the display (usually 7 times).
2. Select a memory channel by pressing and releasing the "/\" or "\/" buttons.
"
If the channel you want to program is the displayed channel when you access
the memory program mode, you must change the channel and return to that
channel before programming is allowed.
3. Press and release the "F" button. The first number (usually will be 0) will flash.
Choose a channel by pressing and releasing the "/\" or "\/" button.
"
The next step has three options. 1. Choosing a "CTCSS" tone. 2. Choosing a
"DCS" tone. 3. Choosing no tone at all.
4. Press and release the "F" button. The next two numbers (usually will be 00) will
flash as well as the "CTCSS" in the upper left of the display. If no tone is desired
go to step 5. Select a "CTCSS" tone desired or press and release the "F" button
again. The "DCS" will begin to flash, select a "DCS" tone desired.
5. Press and release the "ENTER" button to complete the programming.
"
The "CTCSS or "DCS" must be flashing when you press the "ENTER"
button to complete the programming.
"
After pressing the "ENTER" button, the radio will go back to normal
operating mode.

ACCESSING MEMORY CHANNELS

1. Press and release the "F" button repeatedly (usually 6 times) until the display
shows a number in the lower right of the display.
"
This will be the location without the "M" above the number.
"
If the number is flashing this indicates the memory channel has not been
programmed.
2. Press and release the "/\" or "\/" button to select a "Memory Channel"
previously programmed.
"
To exit the "Memory Channel" mode, press and release the "ENTER"
button or press the "F" button twice.
15