Raymarine DSM300 Install Manual page 38

38
The fairing is made of high impact urethane with an integrated cutting guide. It
can be shaped to accommodate a deadrise angle of up to 25° and a range of hull
thicknesses as follows:
Fairing
No.
E66023
E66023
E66025
E66034
Figure 2-9: Deadrise Angle and Fairing Thickness
Backing Block
A backing block is used inside the hull to provide a level surface for the hull nut to
seat against (see Figure 2-9 ). After cutting the fairing, use the remaining section
with the cutting guide as the backing block (see Figure 2-10 ).
Used with Transducer
No. (model)
E66056 (B744V)
E66057 (B744VL)
E66024 (B256)
E66033 (B260)
DSM300 Installation Manual
Max. Hull Thickness
with Fairing
"
1 (26mm)
"
3-3/4 (87mm)
"
1-3/4 (45mm)
"
1-3/4 (45mm)