ANDELI MCT Series Owner's Manual page 13

5.5.5 MMA welding Installation
By pressing function selection button on front panel
By rotating the knob to adjust welding current to start MMA welding.
By pressing setting button
Voltage Reduce Device,when turn it on,No-load voltage will drop to 15V.By pressing setting button (8),
to select and adjust Hot Start current/Hot Start time
start easier and with better welding result.
Note: For details,please refer to Page6, the "Panel description".
WARNING！
It is strictly forbidden to insert or remove any cable or connector in use during the
welding process. This operation will endanger personal safety and cause serious
damage to the equipment.
220V
(7),select to turn ON or OFF VRD function.The VRD function is the
 Connect Electrode holder Quick
Connector to the positive (+) welding
output terminal
 Connect Earth Lead Quick Connector to
the negative (-) output welding terminal
See picture below.
 Connect to AC 220V input voltage,Turn
on the power switch to start
machine.
,to select MMA working mode.
and Arc force current,which make the arc to
12
the