ANDELI MCT Series Owner's Manual page 12

5.5.4 Cutting Installation
By pressing function selection button on front panel
By pressing "Gas Check"
switch to start cutting work.
By pressing setting button
By rotating the knob to adjust cutting current.The cutting thickness increases with the increase of
current.
Note: For details,please refer to Page6, the "Panel description".
220V
Air Compressor
button to check gas.If the gas is normal, press the cutting torch
(6)to adjust Post-Flow time.
 Connect cutting torch to the machine
connector, tighten the nut and connect the
torch switch to the switch control socket,
tighten the nut.
 Connect polar conversion line to the
negative (-)
 Connect Earth Lead Quick Connector to
the
positive (+) output welding terminal. 。
 After install reducing valve,connect Air
compressor to the CUT gas inlet. Connect
to AC 220V input voltage,Turn on the
power switch to start
,to select CUT working mode.
11
the machine.