ANDELI MCT Series Owner's Manual page 11

5.5.3 TIG Welding Installation
By pressing function selection button on front panel
By pressing setting button
2T or 4T working mode.
Under Pulse node, by pressing button
By pressing "Gas Check"
When select "Cold"function, by pressing button
parameter.
Note:Cold welding suitable for thin plate welding.
Note: For details,please refer to Page6, the "Panel description".
gas cylinder
220V
(3)to turn ON or OFF pulse;By pressing setting button (8)to
button to check gas.
10
 Connect Lift TIG torch Quick Connector to
the negative (-) output welding terminal.
 Connect Earth Lead Quick Connectorto
the positive (+) welding output terminal.
 Connect the air hose of Lift tig torch with
the Argon meter connector. See picture
below.
 Connect gas cylinder to the TIG gas
inlet.Turn on the gas valve and adjust to
the desired flow. Connect to AC 220V
input voltage,Turn on the power switch to
start the machine.
,to select TIG working mode.
to select and adjust the welding parameter.
to select and adjust the welding
select