Advertisement
•
Do not modify safety equipment. Check regularly to
be sure it works properly.
•
Inappropriate assembly of this product could cause
severe injuries. Ensure that you follow all the
instructions carefully.
Fuel safety
WARNING:
warning instructions that follow before you
use the product.
•
Fuel is highly inflammable. Exercise care and
refuel outdoors. Fire, open flame and smoking are
prohibited.
•
Bear in mind the risk of fire, explosion and inhaling
fumes. If you spill fuel on yourself or your clothes,
change your clothes.
•
The engine emits carbon monoxide, which is a
colourless, poisonous gas. Do not use the machine
in enclosed spaces.
Safety instructions for maintenance
WARNING:
warning instructions that follow before you
use the product.
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the tine blades
•
Refer to the illustration for an overview of the bolts,
screws, nuts and washers that are necessary to
assemble the tine blades. (Fig. 18)
•
Obey the instructions in the illustrations below.
a) (Fig. 19)
b) (Fig. 20)
c) (Fig. 21)
d) Make a note of the differences between the 2
secondary tine blade holders. Refer to
overview (TF 544+) on page 10 and Product
overview (TF 545D+, TF 545DE+) on page 10 .
Make sure that the secondary tine blade holders
are assembled correctly. (Fig. 22) (Fig. 23)
e) (Fig. 24)
f) (Fig. 25)
Note:
The illustrations only show the assembly
of the tine blades on the right side. The same
instructions are applicable on the left side. Make
1668 - 002 - 10.05.2023
Read and understand the
Read and understand the
Assembly
Read and understand the
Product
•
Always stop the engine before repair, cleaning,
maintenance work or when changing the tools on the
product. Never make adjustments with the product
running.
•
Regular maintenance is essential for safety and to
maintain the levels of performance.
•
Wear heavy-duty gloves when changing the tools on
the product.
•
Replace the rotating blade in complete sets to keep
them balanced. Always use original spare parts.
•
Check that nuts and screws are tight.
•
Never use a product that has a faulty muffler.
Contact an authorized service workshop.
•
For your own safety, do not alter the characteristics
of the product. Do not change the engine speed
settings and do not run the engine at excess speed.
•
Always use original spare parts.
•
When the service life of this product has been
served and it is no longer used it should be returned
to the dealer or to an applicable station for recycling.
•
Make sure to not cut the cables/wires or scratch the
machine when cutting the edges of the case.
sure that the sharp edges point in the same direction
on the right and left tine blades.
To assemble the product
1. Refer to the illustration for an overview of the bolts,
screws, nuts and washers that are necessary to
assemble the product. (Fig. 18)
2. Install the connection joint. (Fig. 26)
3. Install the drag bar. (Fig. 27)
4. Install the handlebar. (Fig. 28)
5. Adjust the height of the handle and tighten the
knobs. (Fig. 29)
6. Adjust the handle left or right and tighten the knobs.
(Fig. 30)
7. Turn the clutch control to the correct side. Attach the
bolt. (Fig. 31)
8. Install the cable cover.
a) Install the cables correctly.
b) Install the rubber holder. (Fig. 32)
c) Install the cable cover and tighten the screw.
(Fig. 33)
9. Install the tine cover:
13
Advertisement
