Assembly; Operation - Husqvarna TF 230 Operator's Manual

Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the tine blades (TF 230)
• Refer to the illustration for an overview of the bolts,
screws, nuts and washers that is necessary to
assemble the tine blades. (Fig. 15)
• Obey the instructions in the illustrations below.
Note:
The illustrations only show the assembly
of the tine blades on the right side. The same
instructions are applicable on the left side. Make
sure that the sharp edges point in the same direction
on the right and left tine blades.
(Fig. (Fig. (Fig.
16) 17) 18)
To assemble the tine blades (TF 338P)
• Refer to the illustration for an overview of the bolts,
screws, nuts and washers that is necessary to
assemble the tine blades. (Fig. 22)
• Obey the instructions in the illustrations below.
Note:
The illustrations only show the assembly
of the tine blades on the right side. The same
instructions are applicable on the left side. Make
sure that the sharp edges point in the same direction
on the right and left tine blades.
(Fig. (Fig. (Fig.
23) 24) 25)
To assemble the product
1. Install the connection joint.
Introduction
WARNING:
safety chapter before you use the product.
1419 - 005 -

Assembly

Read and understand the
(Fig. (Fig. (Fig.
19) 20) 21)
(Fig. (Fig. (Fig.
26) 27) 28)

Operation

Read and understand the
a) For TF 230: (Fig. 29)
b) For TF 338P: (Fig. 30)
2. For TF 230, install the support wheel. (Fig. 31)
3. Install the drag bar.
a) For TF 230: (Fig. 32)
b) For TF 338P: (Fig. 33)
4. Install the handlebar. (Fig. 34)
5. Adjust the height of the handle and tighten the
knobs. (Fig. 35)
6. Turn the clutch control to the correct side. Attach the
bolt. (Fig. 36)
7. Install the cable cover.
a) Install the cables correctly.
b) Install the rubber holder. (Fig. 37)
c) Install the cable cover and tighten the screw.
(Fig. 38)
8. Install the tine cover (TF 230).
CAUTION:
nuts before your tighten them fully.
a) (Fig. 39)
b) (Fig. 40)
c) (Fig. 41)
9. Install the tine cover (TF 338P):
a) (Fig. 42)
b) (Fig. 43)
c) (Fig. 44)
10. Install the gear lever. (Fig. 45)
11. After assembly, tighten all bolts and nuts again.
CAUTION:
product. Speak to an approved servicing
dealer for that task.
To do before you operate the product
• Do an inspection of the work area. Remove all loose
objects that can eject from the product and cause
serious injury to the operator or others. Such items
include stones, glass or steel wire.
• Do a check of the engine oil level and fill engine oil if
it is necessary.
• Do a check of the oil level of the gearbox and fill oil if
it is necessary.
Install the 4 bolts and
Do not disassemble the
11