Advertisement
CAUTION:
nuts before your tighten them fully.
a) (Fig. 34)
b) (Fig. 35)
c) (Fig. 36)
d) (Fig. 37)
e) (Fig. 38)
10. Install the gear lever.
a) For TF 544+: (Fig. 39)
b) For TF 545D+, TF 545DE+: (Fig. 40)
11. After assembly, tighten all bolts and nuts again.
CAUTION:
product. Speak to an approved servicing
dealer for that task.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
•
Do an inspection of the work area. Remove all loose
objects that can eject from the product and cause
serious injury to the operator or others. Such items
include stones, glass or steel wire.
•
Do a check of the engine oil level and fill engine oil if
it is necessary.
•
Do a check of the oil level of the gearbox and fill oil if
it is necessary.
•
Do a check of the fuel level and fill fuel if it is
necessary.
•
Do an overhaul of the product.
a) Replace worn or damaged parts.
b) Do a check for fuel leaks.
c) Make sure that all guards and covers are
installed correctly.
d) Do a check of all nuts and screws.
e) Make sure that the electrical wires are not
damaged.
•
Apply oil to the air filter. Refer to
page 17 for correct oil type.
a) Fill oil until the oil level is between the Max. and
Min. marks. (Fig. 43)
14
Install the 4 bolts and
Do not disassemble the
Operation
Read and understand the
Technical data on
To connect the battery (TF 545DE+)
Recommended battery type is 28 Ah, 12 V.
1. Connect the black battery cable to the negative (–)
terminal on the battery. (Fig. 41)
2. Connect the red battery cable to the positive (+)
terminal on the battery.
To install the PTO connection for
accessories (TF 545D+, TF 545DE+)
•
Install as shown in the illustration. (Fig. 42)
To fill fuel
CAUTION:
cause engine damage. Use diesel fuel
number 0 in the summer and diesel fuel
number -10 in the winter.
1. Stop the engine and let the product become cool.
2. Put the product in an area with good airflow.
3. Fill the fuel tank.
CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
4. Tighten the fuel tank cap carefully to prevent the risk
of fire.
5. Clean the product and the area around the product
from fuel spillage.
6. Move the product 3 m/10 ft or more away from the
refueling area and the fuel source before you start
the engine.
To prepare to start the product
1. Put the gear lever in the neutral gear position. (Fig.
44)
2. Apply full throttle with the throttle control. (Fig. 45)
3. Open the fuel valve. (Fig. 46)
To start the product (TF 544+,
TF 545D+)
1. Push the decompression lever down and hold it
down with one hand.
Incorrect type of fuel can
Make sure that there is
1668 - 002 - 10.05.2023
Advertisement
