Table of Contents
Advertisement
Disposal, recycling of old equipment
8
Disposal, recycling of old equipment
In your own interests and in the interests of the environ-
ment, please ensure that all components of the machine
are disposed of in the proper and approved way.
8.1 Decommissioning
Disused machines must be decommissioned immedi-
ately to prevent misuse at a later point and putting the
environment or persons at risk.
Step 1: Remove all environmentally hazardous fluids
from the old machine.
Step 2: If necessary, dismantle the machine into mana-
geable and usable assemblies and compo-
nents.
Step 3: Guide the machine components and operating
materials to the appropriate disposal routes
8.2 Disposal of lubricants
The disposal instructions for the lubricants used are pro-
vided by the lubricant manufacturer. If necessary, ask for
the product-specific data sheets.
9
Spare parts
DANGER!
Risk of injury caused by the use of
incorrect spare parts!
The use of incorrect or faulty spare parts may cause
risks for operating staff and damage as well as mal-
functions.
- Exclusively genuine spare parts made by the man-
ufacturer or spare parts authorised by the manufac-
turer shall be used.
- Always contact the manufacturer if you are unsure.
Tips and recommendations
Using non-approved spare parts voids the manu-
facturer's warranty.
6
9.1 Spare parts order
Spare parts are available from authorised retailers.
The following key data is required for queries or spare
parts orders:
- Device type
- Item number
- Position number
- Year of construction
- Quantity
- Desired shipping type (post, freight, sea, air, ex-
press)
- Shipping address
Spare parts orders without the aforementioned data can-
not be taken into account. The supplier shall deter-mine
the shipping type if no relevant data was provided.
Data on the machine type, item number and year of ma-
nufacture is listed on the type plate attached to the de-
vice.
Example
The handle for the Four-jaw Chuck Ø 100 mm
M33 x 3,5, Set 2 must be ordered. The handle is identi-
fied in the spare parts drawing with the number 14.
When ordering spare parts, send a copy of the spare
parts drawing with marked component (handle) and mar-
ked position number (14) to the authorised dealer or to
the spare parts department and provide the following in-
formation:
Four-jaw Chuck Ø 100 mm
- Type of device:
5931023
- Item number:
- Position number: 14
Four-jaw Chuck | Version 1.02
M33 x 3,5, Set 2
Advertisement
Table of Contents
