Table of Contents
Advertisement
10 Malfunctions, their potential causes
and remedies
IMPORTANT!
If one of the following malfunctions occurs, immedi-
ately stop working with the machine. Before you start
troubleshooting, turn off the machine and unplug the
power plug. Failure to do so can lead to serious
injury. All repairs or replacement work may be perfor-
med by qualified and trained expert staff only.
Malfunc-
Possible cause
tion
Machine
1. Power plug is
does not
not plugged in.
start
2. Power supply
cables defec-
tive.
3. Switch defec-
tive
4. Motor defective
Strong
1. Loose compo-
vibrations
nent
2. Motor support is
brocked.
3. Motor bearing is
used up
Poor
1. Dust container
extraction
is full
2. Filter is blocked
3. The Extraction
Unit is under-
sized
4. The extraction
line is too long
SAA Series | Version 1.06
Malfunctions, their potential causes and remedies
11 Disposal, reusing used machines
To protect the environment make sure that all machine
components are exclusively disposed of as intended and
legally permitted.
11.1 Decommissioning
Disused machines must be decommissioned immedi-
ately to prevent unintended use at a later point and put-
ting the environment or persons at risk.
Step 1: Disposable environmental in hazardous opera-
Remedy
Step 2: If necessary, disassemble the machine into as-
1. Plug in the po-
wer plug.
2./3./4.
Call a service
Step 3: Dispose of the machine components and proces-
technician
11.2 Disposal of electrical equipment
1. Check all
Electrical devices contain a variety of recycling-capable
connections,
materials and also environmentally hazardous compo-
tighten bolts
nents.
and nuts.
2. Replace the
Separate these components and dispose of them appro-
motor support
priately. In case of doubt, contact your local waste dispo-
3. Replace the
sal authority. Consult a specialist disposal agent for recy-
motor bearding
cling if needed.
1. Empty the dust
container.
11.3 Disposing of lubricants
2. Clean the filter.
3. Use The ex-
Lubricant manufacturers provide disposal information for
traction line
the lubricants used. If necessary, request productspeci-
with Ø larger
fic data sheets.
than100 mm.
4. Set the Extrac-
tion Unit near
on the wood-
working
machine
ting materials from the end of life device.
semblies and components that are easy to
handle and suitable for recycling.
sing materials using the intended disposal me-
thods.
NOTE!
Old chill lubricant emulsions and oils should not be
mixed with each other, because only not mixed waste
oils are usable without pretreatment.
ATTENTION!
Please take care for an environmentally sound dispo-
sal of the used coolants and lubricants. Follow the
disposal tips of your municipal disposal companies.
13
Advertisement
Table of Contents
