Switch On; Seatalk Interface - Raymarine ST600R Owner's Handbook Manual

Chapter 6: Installation
1. Press STANDBY.
2. Select display illumination level 3 on any other SeaTalk instrument

Switch On

Having installed your ST600R, switch on the main power breaker. If
the control head is active and the system operating, the following will
occur:
• The control head beeps and displays the pilot type, ST600R.
• After 2 seconds, the Standby mode screen should be displayed.
stdby
This shows that the control head is active. If the unit does not beep,
check the fuse/circuit breaker.
If "NO LINK" is displayed, check the link between the ST600R
control head and the Course Computer.

SeaTalk Interface

If the ST600R is linked to other SeaTalk instruments via SeaTalk, the
link can be checked as follows:
or autopilot control unit.
STDBY
59
DXXXX-1