Error Codes; Error Codes / Blinking Lights - Whirlpool JDPSS244LM Owner's Manual

ERROR CODES / BLINKING LIGHTS

Code Shown
(7 Seg Display)
Issue
(if present)
Dishwasher fails
to operate fill valve
correctly
Motor controller
failure
No water present at
dishwasher
Wash motor failure F7E1/F7E2
Dishwasher
overfills
Fill valve stuck on
Dishwasher will not
drain
Water present
under dishwasher
User interface
service
communication
fault

ERROR CODES

Code Shown on
Front Panel LED *
(# blinks, Pause, #
blinks)
1 Pause 1 Pause -
F1E1
pause, repeat
1 Pause 2 Pause,
F1E2
repeat
8 Pause 1 Pause -
H2O
pause, repeat
7 Pause 1 Pause,
repeat/7 Pause 2
Pause, repeat
8 Pause 4 Pause -
F8E4
pause, repeat
8 Pause 5 Pause -
F8E5
pause, repeat
9 Pause 1 Pause -
F9E1
pause, repeat
10 Pause 5 Pause -
FAE5
pause, repeat
6 Pause 1 Pause -
F6E1
pause, repeat
What will happen?
Turn off water to unit (if possible).Turn
Drain sequence
off power to unit. If the water cannot
will begin, machine
be turned off, DO NOT turn off power
operation will be and keep door closed. Press Cancel
key one time to silence alarm tone. Call
prevented
service.
Cycle ends Call service
Ensure fill hose is connected to
product. Ensure water supply is turned
Cycle is paused
ON. Press Start to resume cycle. If
alarm still present, call service.
Cycle ends Call service
For Professional Installers
Turn off water to unit (if possible). Turn
off power to unit. If the water cannot
be turned off, DO NOT turn off power
and keep door closed. Press Cancel
key one time to silence alarm tone. Call
service.
For Self Installers
Press CANCEL button twice or cycle
■
power. This may clear the issue.
Check to see if the wire connector is
■
connected to the float switch on the
drip tray. See step 46. If the wire is
Drain sequence
off, reconnect and then hit the cancel
will begin, machine button twice.
operation will be
Check to see if there is any water in
■
prevented
the drip tray. If water is in the drip
tray, remove the water and reinstall
the drip tray. Make sure to connect
the wiring to the float. Step 46.
Check to see where water may have
leaked into the drip tray. (Check the
water inlet fittings in steps 15 and 16
to see if they are leaking)
If water was in the tray and no leaks
■
were found, run the product on the
shortest installation cycle while
checking for leaks. The access panel
should be off to observe any leaks.
If problem still exists, call for service.
■
Turn off water to unit (if possible).Turn
Drain sequence
off power to unit. If the water cannot
will begin, machine be turned off, DO NOT turn off power
and keep door closed. Press Cancel
operation will be
key one time to silence alarm tone. Call
prevented
service.
If drain hose is connected to a garbage
disposal, confirm that drain hose is not
Cycle ends clogged and disposal plug has been
knocked out. If unit still will not drain,
call service.
Cycle ends Call service.
Product will not able to
Call service.
start or resume cycles
What to do?
7