Operating Instructions; Controls On Display Panel - Raymarine L470 Instruction Manual

3 – Operating Instructions
In this section of the manual, we will explain how to operate the unit.
(Setup instructions are included in the next section.) Below is a drawing
of the display unit.
Display
area
Raymarine

Controls on Display Panel

The FishFinder is designed to be easy to use while the boat is moving.
You can steady your hand by gripping the right side of the display with the
fingers of your right hand. This will allow you to use your right thumb to
press the buttons on the display.
Notice that some of the buttons can be used in two ways. They do one job
during a normal display, and a different job when you are setting up the
unit. In this section, we will use symbols like this –
indicate the buttons on the front of the unit.
PWR
This button turns the power on and off.
To turn on the power – Press once to turn the power on.
To enter the Lamp/Contrast Menu – To bring up the
Lamp/Contrast Menu in any operating mode, press the
key for a moment, then release it.
To turn off the power – If you press and hold the button,
the display will say "Powering Off." If you hold the button
for more than 3 seconds, the display unit will switch off.
2 6
Power button
PWR
Page control
pad
Setup button
SETUP
Clear button
CLEAR
ZOOM
Zoom button
A-SCP
BOT
A-Scope button
LOCK
Bottom Lock
FISHFINDER
L470
button
and
PWR

Operating Instructions

Fig. 3-1
Display
Panel
– to
SETUP
PWR