Extron electronics Cable Cubby 1200 Installation Manual page 5

Cable Cubby 1200 and 1400 • Installation Guide (Continued)
Under the table, adjust the side clamps on the enclosure.
3
Ensure the Cable Cubby
is rmly seated in the table.
Raise the lever to secure
the Cable Cubby.
Lever
1
Lever
1
Rotate the side clamp
outward and ensure that
the lever is down.
Mounting Retractors Under the Table
n.
2
Insert the pin through the
retractor mounting hole on
the side of the Cable Cubby
and retractor assembly.
2
Insert the pin through the
retractor mounting hole on
the side of the Cable Cubby
and retractor assembly.
2
Rotate the side clamp
outward and ensure that
the lever is down.
2
Slide the clamp all the
way up against the bottom
of the table.
1
Insert retractors into
the retractor bracket.
4
Secure the locking screw on each
retractor. Do not overtighten.
Insert retractors into
3
Slide the clamp all the
way up against the bottom
of the table.
3
Ensure the Cable Cubby
is rmly seated in the table.
Raise the lever to secure
the Cable Cubby.
3
Secure the clip on the pin.
3
Secure the clip on the pin.
NOTE:
clamp, turn the lever
Ensure the Cable Cubby
down, then press and
is rmly seated in the table.
Raise the lever to secure hold the locking plate
the Cable Cubby.
while sliding down the
clamp.
Locking
plate
Horizontal or Angular Mounting
For horizontal or angular mounting, remove
these orientation screws (front and back),
then follow the steps shown at left.
For installation details, see the Cable Retractor
Setup Guide available online at www.extron.com.
To lower the side
5